Circular Saw Lower Guard Test Device HDD8302
Standard: IEC 60745-2-5 : Particular requirements for circular saws, clause 19.102.3 and Annex BB, EN 60745-2-5
Application: This device is applicable to test the closing time and mechanical strength of lower guard for circular saws.
Test sample: Circular saws
Feature: The saw is to be set for a 90°cut and oriented in the horizontal plane. The lower guard is to be cycled from the full closed position to the maximum open working position and then released for 50000 cycles at a rate not less than 10 cycles per minute. The cycle numbers recorded by a position sensor. Following the cycle, the closure time shall not exceed 0.3s. The device record the times when detected closure time exceed 0.3s. When preset test times completed, device record the last closure time and stop automatically.
Parameters:
|
No.
|
Item
|
Specification
|
Remark
|
|
1
|
Power supply
|
220V/50Hz
|
|
|
2
|
Electrical control
|
MITSUBISHI PLC operation,
7 Inch Touch screen operation
|
|
|
3
|
Drive
|
Motor
|
|
|
4
|
Test times
|
0-999999 times, preset
|
|
|
5
|
Detection time
|
0-9.99s, display
|
Closure time
|
|
6
|
Automatic / manual speed
|
0-30 times / min, can be preset
|
|
|
7
|
Manual state rotation
|
Touch control,
clockwise or counter clockwise
|
|
|
8
|
Dimension
|
80*70*100cm, about 80kg
|
|
Our Team
Responsibility is the assurance of quality, and quality is the life of corporation. We are looking forward to long term cooperation with customers, we will make best service and after sales service for all of our customers. If you have any inquiry, please don’t hesitate to contact us. We will reply you at the first time as we can.
We are looking forward to long term cooperation with customers, we will make best service and after sales service for all of our customers. If you have any inquiry, please don’t hesitate to contact us. We will reply you at the first time as we can.
Our Service
7X24-hour Telephone Consulting Service is available.
Reply and solution will be provided in 8 hours upon customer’s service request.
After-sales Support is available on a 7X24-hour basis, leaving no worries for customers.
Quality inspection from raw material to production, and delivery.
Professional quality control person, to avoid the unqualified products flowing to customer.
Strict inspection to Raw material, production, and delivery.
Full series of equipment in quality laboratory.
Product Tags:
|
|
IEC 60745 2 5 Electric Testing Equipment Circular Saw Lower Guard Test Images
|
